It is widely used in our daily life, but there are many laymen who are not very familiar with aluminum panels. When processing aluminum panels, waste often occurs, which inevitably leads to waste. Below is an introduction:
How to reduce unnecessary waste of aluminum panels? Follow the manufacturers of alloy aluminum plates to learn about it.
1. Kneading and straightening link
Straightening is a relatively simple process that can lead to twists and turns in the profile. The operator must pay attention to the force used for straightening. Assuming that the force is too large, the profile may simply produce deformation, necking, orange peel, and other phenomena. However, if the force is too small, the profile may not be straightened, resulting in twists and turns in the profile.
2. Kneading and framing
This link is also very important. After sawing the fixed length, generally, the aluminum plate needs to be framed. At this time, it should be noted that this material is large or small, whether it is a tube material or a flat die drawn material.
Generally speaking, lifting the two ends of large materials and materials with tubes to frame does not simply constitute a zigzag, but lifting the two ends of small materials and materials pulled out of the plane mold can easily constitute a zigzag. At this time, it is necessary to lift the materials from both ends to the center for framing. However, even if this is not possible for some profiles, we need to place this type of material on the aged profile and then lift it into the frame.
3. Surface treatment on shelf
After aging, the hardness of the blank has reached the standard, and the profile will not be so prone to bending. However, it is important to pay attention when placing on the shelf. When lifting the material at both ends, try to avoid strong fluctuations up and down to avoid bending of the aluminum plate.